S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Shift Solenoid: Service and Repair
Control System/Valve Housing, Removing
Control system/valve housing, removing
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Note! Read through the instructions before beginning to work.
Information before removal
When replacing the valve housing, the distribution plate and all 6 balls (if undamaged) should be transferred to the new valve housing. There are many
screws of different lengths. It is important that the different screws are not mixed up. Checks are carried out when replacing the valve housing.
The new valve housing does not have any solenoids installed. The solenoids are loose in the kit and must be installed separately.
Removing the side cover
Remove the side cover. See Removing gearbox side cover See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and
Repair/Removal and Replacement/Automatic Transmission Components/Removing Gearbox Side Cover.
Preparations for removing the valve housing
Remove the cable harness. See Cable harness, control system, transmission, replacing See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Wiring Harness/Service and Repair.
Remove the oil pump. See Replacing the oil pump See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Fluid Pump/Service and Repair.
Air vent housing
