S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
-
the rear seat seat cushion according to Cushion
-
the C and D post panels according to Panel, C-post, replacing See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and
Repair/Panel, C-Post, Replacing.
Separate the connector on the floor.
Detach the cable at the C and D-posts.
Detach a corner of the inner module from the glass. Use weatherstrip tool 981 4071 STRAIGHTENING TOOL See: Tools and Equipment/981 4071
Straightening Tool. Pull off the module.
Installing the inner module
Clean the glass using a razor blade or similar.
Clean the glass using the cleaning cloth supplied with the inner module.
Cut out a template corner to corner with the outer module.
Position the template edge to edge with the outer module. Tape the template into place.
Note! The outer and inner modules must be positioned opposite each other.
To ensure optimal adhesion, carefully heat the glass. Use a hot-air gun or similar.
Remove the backing from the inner module.
Position the module in the correct place on the glass. Press the module into place. Press the module against the glass for 3-4 seconds.
Note! Ensure that the tape adheres correctly all the way around the mounting for the inner module.
Remove the template.
Reinstall other components in reverse order.