S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Remove the cover over the fuel pump (FP).
Separate the connector for the wheel sensor.
Install a piece of cable on the connector. Pull the cable from underneath between the tank and bodywork.
Disconnect the cable from the connector. Leave the cable in place.
Remove the wheel sensor
Note! Blow clean around the sensor using compressed air before removing.
Remove the mounting screws for the sensor. Pull out the sensor.
Disconnect the wiring from its brackets.
Remove all the sensor wiring.
Installation
Install the wheel sensor
