S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Apply a little automatic transmission fluid on the sensor O-rings.
Install:
-
the pressure sensor
-
the screws loosely (finger tight).
Note! The upper screw is a M10 screw head. The three long screws are M8. The two shiny short screws are self tapping and should go into the
same threads as before.
Tighten the screws lightly crosswise. The tighten to the black screwsto 12 Nm.
Then tighten the two self tapping screws to 8 Nm.
Install:
-
the connector
-
the clip for the cable harness for the pressure sensor.
Installing the transmission side cover
See Installing the gearbox side cover See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Automatic Transmission Components/Installing the Gearbox Side Cover.
