S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
9. Installing the new ball joint, continued
Press the ball joint up against the seat. Use press tool 999 5796. Check that the ball joint is centered in the seat.
Knock in the ball joint. Use a copper mallet. Remove the guide screws.
10. Installing the new ball joint, continued
Tighten the ball joint. Use new screws.
Tighten to 50 Nm.
Remove the protective cap (1).
11. Installing the new ball joint, continued
Press down the control arm. Use lever 999 7076. Position the hook at (1).
NOTE: If the hook is positioned at point (2) there is a risk of damaging the rubber boot on the ball joint.
Align the spring strut in the control arm. Important! Do not pull the drive shaft as the axial pinions cannot support large loads.
