S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
-
Align the bushing with the control arm as above.
-
Press in the bushing. Use tool 999 2852 MOUNTING RING See: Tools and Equipment/999 2852 Mounting Ring and 999 7308 Drift See: Tools
and Equipment/999 7308 Drift
-
Press the bushing in until the outer sleeve of the bushing contacts the tool 999 2852 MOUNTING RING See: Tools and Equipment/999 2852
Mounting Ring
Removing the rear bushing
-
Place the control arm in a workshop press.
-
Use: 999 5624 Counterhold See: Tools and Equipment/999 5624 Counterhold and 999 7209 Socket See: Tools and Equipment/999 7209 Socket.
-
Press out the bushing.
Installing the rear bushing
Note! Note that the bushing's inner sleeve is longer on one side. This side must point upwards.
Press in the bushing to the specified dimension (40 mm), measured between the control arm's machined surface and the bushing's inner sleeve.
