S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Clean the splines on the drive shaft.
Turn in the wheel spindle and locate the drive shaft in the hub.
Install drive shaft screw and finger-tighten. Lubricate the screw.
Install
-
both screws retaining the spring strut in the wheel spindle. Use new screws and nuts.
Adjust the position of the wheel spindle and spring strut. See Wheel knuckle / spring strut, calibrating See: Front Steering Knuckle/Service and
Repair/Procedures. Tighten to 105 Nm. Angle-tighten 90°. Use a bevel protractor 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951
2050 Bevel Protactor.
-
the anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm. Counterhold with a Torx wrench so that the boot is not damaged
-
the ABS sensor cable
-
ABS sensor onto the wheel spindle. Tighten the ABS sensor. Tighten to 10 Nm.
Note! Ensure that the sensor seat in the wheel spindle is completely clean. Clean the ABS sensor with a soft brush.
-
the tie rod end on the wheel spindle. Use a new nut.
Tighten the steering arm on the wheel spindle. Refer to: Tightening torque See: Steering/Specifications/Mechanical Specifications/Tightening Torque
