S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Suspension Strut / Shock Absorber: Procedures
Wheel knuckle / spring strut, calibrating
Measuring before removal
The measurements are made so that the same camber angle can be obtained when installing.
Measure over the wheel spindle / spring strut at the upper screw as illustrated.
Before measuring clean off any dirt from the measuring surfaces.
Note the measurement.
Installing the spring strut / wheel spindle
Install the spring strut on the wheel spindle. Use new screws and nuts.
Adjust in accordance with the measured values.
Tighten to 105 Nm. Angle-tighten 90°. Use bevel protractor 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protactor.
