S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
Seals and Gaskets: Service and Repair
Replacing the pinion seal for the bevel gear
Special tools:
999 5743 Counterhold See: Tools and Equipment/999 5743 Counterhold
999 5759 Adapter flange All-wheel drive.
999 5069 EXTRACTOR See: Tools and Equipment/999 5069 Extractor
999 5504 PRESS TOOL, DRIVE FLANGE See: Tools and Equipment/999 5504 Press Tool, Drive Flange
999 5652 Counterh. See: Tools and Equipment/999 5652 Counterh.
999 5653 Punch See: Tools and Equipment/999 5653 Punch
999 5682 Tensioner band See: Tools and Equipment/999 5682 Tensioner Band
999 5893 Puller See: Tools and Equipment/999 5893 Puller
Note! Check that the parking brake is not applied or that a gear/position P is engaged.
Removal
Removing the three-way catalytic converter (TWC)
Remove the three-way catalytic converter (TWC) See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair.
Note! The rear pipe must be supported at the front. Tensioner band 999 5682 Tensioner band See: Tools and Equipment/999 5682 Tensioner
Band can be used to support the pipe.
Marking the propeller shaft and flange
Mark the propeller shaft CV joint in relation to the bevel gear flange
Remove the screws from the propeller shaft.
Use counterhold 999 5743 Counterhold See: Tools and Equipment/999 5743 Counterhold.
Removing the propeller shaft
Slacken off the support for the centre bearing from the propeller shaft and body.Turn the support upside down. Let the propeller shaft rest on the support.
