S80 T6 L6-2.9L Turbo VIN 91 B6294T (2002)
NOTE: Do not apply rust solvent spray or grease to the Heated Oxygen Sensor (HO2S) or combined instrument panel connectors.
-
Ignition off
-
Disconnect the battery negative terminal
-
Use compressed air to clean the disconnected connector
-
Apply rust solvent spray 1161422 to the disconnected connectors
-
Blow clean using compressed air.
NOTE: Do not fill the protective cover with grease.
-
Press grease, P/N 1161417-9, into the terminals directly from the tube
-
Check that all the cavities in the connectors are filled
-
Use a loose male pin to ensure that contact in sockets is good. The pin should remain in position when pulled gently.
Cable Terminals, Different Types
Cable terminals, different types
Warning! SRS No cable repair or other repair work may be carried out on the SRS system wiring.
The part numbers of the cable terminals are not given here. Look at the picture on the inside of the box containing the cable terminals, check the
Contents table in the chapter Special Tools and the Spare Parts Catalogue for the model concerned.
