S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Applies to cars up to and including model year 2004
-
Connect the routed red/white cable to the outer position (1) on the reverse side of fuse socket 10 on the fuse holder. Remove the decal (2).
Carefully prize up the red secondary catch on the end face of the end closest to position 10 at the same time as the cable is pressed into place.
Hint: If there is a problem in routing the cable there then the fuses on the outer side must be removed so that the red secondary cable can be
opened further.
-
Reinstall the decal.
-
Install a 10A fuse in fuse socket 10 on the fuse holder.
-
Reinstall the fuse holder. Make sure that the cable does not chafe against sharp edges.
-
Clamp in the cable at the existing cable harnesses using three tie straps from the kit.
For cars from model year 2005-
-
Press in the catch on the rear brown connector in the cargo compartment fuse holder. Turn up the lock arm as far as possible and pull out the
connector.
For cars from model year 2005-
-
Carefully pry apart the sides of the connector holder in the ends so that the connector can pass by the retaining hooks.
-
Pull out the connector.
