S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Was a fault detected?
Yes - FAULT FOUND
No - Checking the M2D control module
-------------------------------------------------
Checking the M2D control module
Check the cable terminals on the connector for the M2D control module. The cable terminals must not be damaged, pressed back or oxidized.
Check that the connectors for the M2D control module are connected. See positions 1-5.
Remedy as necessary.
Other information:
-
To access or replace the fuses, see Location of fuses in the rear center console Executive See: Maintenance/Fuses and Circuit
Breakers/Fuse/Locations/Location of Fuses in the Rear Center Console Executive
-
To fault-trace wiring and terminals, see Checking wiring and terminals See: Testing and Inspection/Component Tests and General
Diagnostics/Checking Wiring And Terminals
-
To access or replace the M2D control module, see Road traffic information module (RTI), replacing See: Navigation System/Navigation
Module/Service and Repair/Road Traffic Information Module (RTI), Replacing.
Hint: The above illustration shows the location of the M2D control module on the RTI unit.
-
For information about signals and connectors, see Signal specification, RTI (road traffic information) Executive See: Navigation System/Testing
and Inspection/Pinout Values and Diagnostic Parameters/Signal Specification/Signal Specification, RTI (Road Traffic Information) Executive
-
For additional information about sound and picture related faults, see Checking the picture on the rear display screen.
