volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Check the Switch for the DVD|Page 14484 > < Check the Switch for the DVD|Page 14482
Page 3
background image

Was a fault detected?

Yes - FAULT FOUND

No - Checking the cable between the DVD unit and the transformer

-------------------------------------------------

Checking the cable between the DVD unit and the transformer

Check that the connectors for the transformer and DVD unit are connected. See position 9.
Check the supply voltage from the transformer to the DVD unit between terminals #P1 and #P2, see position 9.
The voltage must be approximately 9 V.
Check the cable between transformer terminal P and the DC plug connector on the DVD unit. Check for an open-circuit. Check for a short-circuit to
ground.
Remedy as necessary.

Other information:

-

To access or replace the fuses, see Location of fuses in the rear center console Executive See: Maintenance/Fuses and Circuit
Breakers/Fuse/Locations/Location of Fuses in the Rear Center Console Executive 

-

To fault-trace wiring and terminals see Checking wiring and terminals See: Testing and Inspection/Component Tests and General
Diagnostics/Checking Wiring And Terminals 

-

To access or replace the DVD unit, see Replacing the DVD See: Service and Repair 

-

To access or replace the cable between the DVD unit and the transformer, see Replacing the cool box See: Refrigerator/Service and
Repair/Replacing the Cool Box 

-

For information about signals and connectors, see Signal specification, RTI (road traffic information) Executive See: Navigation System/Testing
and Inspection/Pinout Values and Diagnostic Parameters/Signal Specification/Signal Specification, RTI (Road Traffic Information) Executive.

Check the Switch for the DVD|Page 14484 > < Check the Switch for the DVD|Page 14482