S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
-
Tighten the screw (2). Tighten the nut (3). Tighten to 87 Nm (65 lbf.ft)
-
Tighten the screw (11). Tighten to 120 Nm (90 lbf.ft.)
-
Ensure that the washer on the sleeve (12) is parallel to the spare wheel well. (Illustration D).
-
Wait at least five minutes, so that the joint has time to set. Then tighten the screws (11) on both sides. Tighten a quarter turn (angle tighten 90°).
Note! Torque tightened screws that have been removed must not be reused.
-
Underseal the car.
Applies only to Sweden
-
Carry out this operation only after the state road worthiness inspection.
Reinstall:
-
the bumper. Locate the ends of the bumper (1) in the rails (2). Push the bumper in
-
the wheel nuts. Tighten to 18 Nm (14 lbf.ft)
-
the rubber seal
-
the connector for the aerial.
-
Install the liner for the bumper cover. Rivet the liner on both sides
-
Reinstall the wheels. Tighten to 140 Nm (104 lbf.ft).
Illustration A
