S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
-
Route the cable harness from the tow bar connector through the hole in the floor
-
Adjust the position of the rubber seal (1) so that there is not too much slack in the cable under the car
-
Install the rubber seal in the hole
-
Connect the drainage hose (2) to the battery
-
Route the cable harness (3) along the existing wiring
-
Install the clamps (4)
-
Connect the cable harness connector (5) to the existing connector (6)
-
Clamp any excess cable together with the connector.
Applies to cars with two rows of seats
1. Release the restraining strap for the jack and lift it out.
Illustration A applies to cars with two rows of seats
Illustration B applies to cars with three rows of seats