S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
The second part of the designation is a serial number, for example, x/2.
Combined these give a component designation, for example, 3/2.
At the end of the manual is a list of components, where, with the help of the component designation, you can read off the name of the component, for
example, 3/2 = Light switch. See: Diagrams/Diagram Information and Instructions/Diagram Legend
List of type numbers
The list shows which type of component that respective type numbers refer to, for example, 3/x = switch, 6/x = electric motor, etc.
1
Battery
2
Relay
3
Switch
4
Control module
5
Combined instrument panel
6
Electric motor
7
Sensor
8
Actuator
9
Heating element
10
Lamp
11
Fuse
15
Distribution rail
16
Audio
17
Service/diagnosis
18
Contact reel
19
Meter
20
Ignition component/shunt
31
Ground connection
53
Junction point
54
Connector
B. Junction points
The wiring diagrams contain numbered junction points, e.g. 53/352.
This manual contains a section with a list of junction points. This list shows all the components which are connected to each junction point. See: Power
and Ground Distribution/Branching Point/Diagrams/Electrical Diagrams
The location of the junction points is shown in the Vehicle level Harness Locations images. See: Locations/Harness Locations
C. Connectors
Connectors provide a bridge between two cables harnesses and are described in the Vehicle Level Connector Views. See: Diagrams/Connector Views
D: Electrical distribution
Operation of the fuses and relays is shown in the Power and Ground Distribution Diagrams. See: Power and Ground Distribution/Diagrams/Electrical
Diagrams
E. Data communication
Today's cars are equipped with a CAN network, which transmits information. Connections to this network are shown in their entirety on the respective
wiring diagrams. Complete information on CAN communication can be found in Information Bus. See: Powertrain Management/Computers and Control
Systems/Information Bus
F. Abbreviations
A number of different abbreviations are used in the diagrams. These are explained in "Wire Color Code Identification and Other Abbreviations". See:
Diagrams/Diagram Information and Instructions/Wire Color Code Identification and Other Abbreviations
G. Component location
The appearance and location of components is described in alphabetical order at the Vehicle Level component locations A - Z Component List. See:
Locations/Component Locations/A - Z Component List