S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Angle out the lock mechanism.
Remove the cable harness.
Unhook the end of the cable.
Installing the lock mechanism for the rear side door
NOTE: For tightening torques, see Specifications.
Angle in the lock mechanism.
Install:
-
the 3 M6 screws. Tighten
-
the link between the lock mechanism and the outer handle
-
the link for the lock button.
Work the guide rail back into place.
Install the screw for the guide rail. Tighten.
Install:
-
the connector
-
the end of the cable
-
the run-off profile. See Drip guard
-
the door panel.