S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Install the pressure sensor.
Tighten to 25 Nm.
Connect the connector.
Remove the pedal jack.
Checking the pressure sensors visually
Switch on the ignition. Wait for 5 seconds. The symbol on the dashboard should go out.
Bleeding the brake system
With the bleeding unit. Brake system, bleeding (using bleeding unit) See: Brake Bleeding/Service and Repair/Brake System, Bleeding (Using Bleeding
Unit)
Without the bleeding unit. Brake system bleeding See: Brake Bleeding/Service and Repair/Brake System Bleeding
Airing
Bleed the circuit that the pressure sensor is on.
If both the pressure sensors have been replaced, bleed the whole system.
Checking the brakes
Brake disc, calibrating See: Disc Brake System/Brake Rotor/Disc/Testing and Inspection
Relay box - air cleaner (ACL) housing
Brake pipe master cylinder / ABS unit, replacing See: Brake Hose/Line/Service and Repair/Brake Pipe Master Cylinder / ABS Unit, Replacing
Air cleaner (ACL)
Brake pipe master cylinder / ABS unit, replacing See: Brake Hose/Line/Service and Repair/Brake Pipe Master Cylinder / ABS Unit, Replacing