S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
-
the new cover in the rear edge of the camshaft
-
the intake pipe between the charge air cooler (CAC) and the electronic throttle module (ETM).
Install the auxiliaries belt around the pulley on the crankshaft.
Install:
-
the plastic nuts for the cover in the right-hand wing liner
-
the right front wheel. See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.
Install:
-
front timing cover. Tension the auxiliaries belt. Check that it is correctly positioned on all pulleys
-
the expansion tank
-
the hose between the expansion tank and the radiator. Remove the lock grip pliers
-
the servo reservoir
-
the upper timing cover.
Twist the intake pipe for the turbocharger for cylinders 1, 2 and 3 into position. Tighten the clamp. Install the plastic hoses between the turbocharger
(TC) and the charge air cooler and between the air cleaner (ACL) and the turbocharger (TC). Tighten the hose clamps.
Install:
-
the engine stabilizer brace. Tighten the screws
-
the screw holding the engine stabilizer brace to the bracket on the engine. Tighten
-
the battery negative lead. Also read Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
Final check
Check and top up if required:
-
coolant level
-
the servo fluid level.
Test drive the engine.
Removing/Installing the rear camshaft seal
Preparation
