S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Oil Pan: Service and Repair
Replacing the oil pan
Special tools:
951 1205 See: Tools and Equipment/951 1205
999 5460 Lifting hook See: Tools and Equipment/999 5460 Lifting Hook
999 5716 Reading off tool See: Tools and Equipment/999 5716 Reading off Tool
999 5717 Lifting eye See: Tools and Equipment/999 5717 Lifting Eye
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.
Preparation
Remove the oil dipstick and pipe.
Turbocharged engines only
Remove:
-
the connector and hose from the crankcase ventilation terminal in the plastic intake pipe
-
the hose from the plastic charge air pipe
-
the screws for the charge air pipe in the intake pipe.
Remove:
-
the hose clamps from the plastic pipe at the rear of the engine
-
the plastic pipes. If necessary, heat carefully using a hot air gun. Leave the pipes lying on the spark plug cover.
Installing the lifting fixture
Remove:
-
the cover over the ignition coils
-
the 2 screws at the engine mounting.
Install fixture999 5717 Lifting eye See: Tools and Equipment/999 5717 Lifting Eye.
Installing the lifting beam and lifting hook on the engine lifting eyelet
