S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
-
the cross stay between the suspension turrets.
-
plastic pipes, intake/charge air over the engine.
-
upper coolant hose engine/radiator.
-
solenoid valve (turbo control) from the air cleaner.
-
the air cleaner inlet pipe from the connection on the front cover plate.
-
the air cleaner assembly.
Relieve the load from the belt tensioner. Remove the auxiliaries belt.
First remove the upper timing cover and then the front timing cover.
Remove the cover over the ignition coils.
Draining the fuel line
Drain the fuel line. See Fuel system pressure release See: Cylinder Head Assembly/Fuel Pressure Release/Service and Repair/Fuel System Pressure
Release.
Removing the fuel rail
Remove
-
the brake vacuum hose from the intake manifold.
-
the charge air pipe from the throttle body (electronic throttle module).
-
the dipstick tube from the intake manifold.
-
the pipe screw for the crankcase ventilation connection at the intake manifold.
-
the vacuum hose from the charge air bypass valve
-
the rear screw in the lower row from the connection between the intake manifold and the cylinder head; remove the bracket.
-
the protective cover over the nozzle connectors.
-
the fuel rail mounting screws.
Spray universal oil or similar around the injector connectors on the intake manifold.
Gently work the fuel rail and injectors loose.
Separate the fuel line quick-release connector under the intake manifold. Use tool 951 2666 Replaced by 9997298 See: Tools and Equipment/951 2666
Replaced by 999 7298.
Carefully put the fuel rail to one side.
Remove the EVAP valve hose from the intake manifold
Removing components
