S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
-
the screws for the 2 ground terminals between ignition coils 1 and 2 and 5 and 6.
Install below the intake manifold
-
the starter motor.
-
the throttle body connector to the engine wiring.
-
the charge air pipe to the throttle body. Tighten the clamp.
-
the control hose to the charge air bypass valve.
-
the brake vacuum hose to the intake manifold.
-
the bracket and screw to the lower row of screws at the mounting for the intake manifold on the cylinder head.
-
the pipe screws at the underside of the intake pipe for the water heated crankcase ventilation. Tighten to 26 Nm.
-
the dipstick tube to the intake manifold.
Installing the fuel rail
Install
-
the fuel rail. Use new screws. Tighten to 10 Nm. Press the quick-release connector for the fuel pressure line until there is an audible click.
-
the clamps holding the injector wiring and the positive cable to the rear edge of the cylinder head.
-
the protective cover over the nozzle connectors.
-
the upper coolant hose to the cylinder head/radiator. Tighten the clamp.
Installing the coolant pump intake pipe
