S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Install
-
the cable duct on the inside of the right suspension turret.
-
the front timing cover.
-
the expansion tank. Connect the connector to the coolant level sensor.
-
the hose to the expansion tank from the radiator. Secure the clamp and remove the lock grip pliers.
Connect the connector to the ABS sensor.
-
servo reservoir. Ensure that the hoses are correctly positioned.
Install
-
the upper timing cover.
-
the cover over the ignition coils.
-
the plastic intake pipe over the engine. Adjust and tighten the intake pipe at the turbocharger. Tighten the clamps and mounting screws on the
plastic pipe.
-
the plastic charge air pipe over the engine. Tighten the clamps and mounting screws.
-
the hose between the charge air cooler and the plastic charge air pipe over the engine. Tighten the clamps.
-
the crankcase ventilation hose to the PTC resistor in the plastic intake pipe over the engine. Use a new clamp.
-
the connector for the PTC resistor.
-
the protective cover over the PTC resistor.
-
the EVAP valve hose to the plastic intake pipe.
-
the bypass valve outlet hose to the plastic intake pipe. Tighten the clamp.
-
the air cleaner assembly. Press the air cleaner intake pipe into the front plate port.
-
the plastic intake pipe to the mass air flow sensor. Tighten the clamp.
-
the connector to the mass air flow sensor. Clamp the wiring at the front edge of the air cleaner.
-
the turbocharger control valve to the mounting on the air cleaner
-
the blue-marked hose/turbocharger control system to the intake manifold.
-
the red-marked hose/turbocharger control system to the charge air pipe.
-
the yellow-marked hose/turbocharger control system to the pressure regulators.
-
the cross stay between the suspension turrets
-
the suspension turret covers.
Clamp the servo hose to the right mounting on the cross stay.
Exhaust system assembly
