S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Front Crankshaft Seal: Service and Repair
Oil pump / crankshaft seal, front, replacing
Special tools:
999 5304 SEPARATOR See: Tools and Equipment/999 5304 Separator
999 5919 PULLER See: Tools and Equipment/999 5919 Puller
999 5455 PUNCH See: Tools and Equipment/999 5455 Punch
999 5433 COUNTERHOLD See: Tools and Equipment/999 5433 Counterhold
Preparation
Remove the timing belt. See Replacing the timing belt See: Timing Components/Timing Belt/Service and Repair/Removal and Replacement.
Check the tensioner and idler pulleys. See Replacing the timing belt See: Timing Components/Timing Belt/Service and Repair/Removal and
Replacement.
Carefully pull away the timing gear pulley. Use puller 999 5304 SEPARATOR See: Tools and Equipment/999 5304 Separator.
When only replacing the front crankshaft seal
Remove the old seal. Use extractor 999 5919 PULLER See: Tools and Equipment/999 5919 Puller.
Clean sealing surfaces.
Lubricate and install the new seal. Use drift 999 5455 PUNCH See: Tools and Equipment/999 5455 Punch.
Press in drift and seal with crankshaft center nut.
Note! Ensure that the crankshaft does not rotate when pressing in the crankshaft seal.
Removing oil pump