S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Remove
-
the air cleaner (ACL) intake pipe
-
the mounting screws for the starter motor. Pull off the starter motor. Place the starter motor to one side
-
the blind cover plug and the seal washer.
Turn the crankshaft
clockwise.
Install the crankshaft stop999 5451 ADJUSTMENT TOOL See: Tools and Equipment/999 5451 Adjustment Tool Ensure that it bottoms out against the
cylinder block.
Turn the crankshaft
counter-clockwise until it stops against the crankshaft stop.
Check that the marking on the crankshaft timing gear pulley corresponds with the marking on the oil pump.
Installing the camshafts timing gear pulleys (B6284T)
Timing gear pulleys with variable valve timing units
Slacken off, but do not remove the screws which secure the timing gear pulley to the variable valve timing unit.
Press the variable valve timing unit / timing gear onto the camshaft.
Install the center screw which secures the variable valve timing unit to the camshaft. Tighten slightly.
Position the upper timing cover.
Turn the timing gear pulley clockwise until the screws at the oval holes are in the limit position.
Continue turning clockwise until the timing gear pulley marking is
1½ tooth before the marking on the upper timing cover.