S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
(The car is not correct because the pulsed secondary air injection system (PAIR) pump has been discontinued.)
-
the screw for the upper mounting for the automatic transmission dipstick pipe. Slacken off the screw on the lower mounting
-
the intake manifold and the charge air pipe to turbo 2. Seal the openings
-
the heat deflector plate from turbo 2
-
the expansion tank cap.
Raise the car.
Remove the left front wheel.
Remove the splash guard under the engine.
Connect a hose to the engine drain cock. Drain the coolant into a clean container.
Close the cock.
Remove
-
the rear SIPS member
-
the nuts for the rear flange seals on the catalytic converters
-
the nuts for the front flange seals on the catalytic converters.
Expose the heated oxygen sensor (HO2S) wiring. Disconnect the connectors.
Disconnect the brake pipe from the holders on the front SIPS member.