S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Note! Ensure that the guide for the end mounting is correctly positioned during installation. (The end mounting must be pointing forwards at
an angle of 45°).
Install:
-
the screw for the end mounting. Tighten to 48 Nm
-
the seat belt (inertia) reel nuts. Tighten to 48 Nm
-
the connector. See Igniter wire connector See: Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Igniter Wire Connector
-
the parcel shelf. See Parcel shelf, replacing See: Body and Frame/Interior Moulding / Trim/Rear Shelf/Service and Repair
-
the rear seat cushion. See Rear seat assembly See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat/Rear Seat
Assembly
-
the seat belt in the seat belt guide
-
Then check the seat belt function.
Replacing seat belt buckles
Removing front seat belt buckle
Remove:
-
the seat from the car. See Lifting the front seats in and out See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front
Seat/Lifting the Front Seats In and Out. Disconnect the connector from the seat frame
-
the tie straps (x 2) for the cable harness
-
screw (1)
-
the seat belt buckle.
Removing rear seat belt buckles
