S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
NOTE: If the hook is positioned at point (2) there is a risk of damaging the rubber boot on the ball joint.
Release the spring strut from the control arm. Important! Do not pull the drive shaft as the axial pinions cannot support large loads.
4. Removing the ball joint, continued
Remove the screws on the ball joint.
5. Removing the ball joint, continued
Install:
-
nut 999 7148 on the ball joint
-
slide hammer 999 2709 on the nut.
Tap off the ball joint.
6. Cleaning the ball joint mounting
Warning! Use protective goggles.
Clean the ball joint seat and the mating surfaces for the ball joint to the wheel spindle. Use a rotating wire brush. Lubricate the seat using wheel