S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
-
Install the hydraulic cylinder
-
Use tool951 2923 Hydraulic hole cylinder See: Tools and Equipment/951 2923 Hydraulic Hole Cylinder with 999 7054 Adapter incl. 2x MC6C
M6X12 See: Tools and Equipment/999 7054 Adapter incl. 2x MC6C M6X12 , 999 7035 Sleeve See: Tools and Equipment/999 7035 Sleeve , 999
7036 Drift See: Tools and Equipment/999 7036 Drift , 999 7038 Drift See: Tools and Equipment/999 7038 Drift and 999 7039 Connecting rod
M16X360 See: Tools and Equipment/999 7039 Connecting Rod M16X360
-
Pull the bushing.
Note! If necessary, tighten the nut on the tool after pressing approximately halfway.
Installing the wheel spindle and tie rod
Install:
-
the wheel spindle
-
the screw for the lower and upper control arm mounting
-
the tie rod screw.
Note! Do not tighten the screw for the bushing mountings. This is carried out later when the rear suspension is in the normal position.
Installing the lateral link
Release the tension from the tensioner and allow to hang freely.
Install:
-
the retaining strap and secure the lower control arm slightly against the jacking point
-
the screw for the lateral link.
Remove the retaining strap.
Tightening the stay and mountings
Press the suspension up to its normal position, see Tensioner, instructions for use, AW55-50/51SN, 4T65EV-GT See: Service and Repair/Removal and
Replacement/Tensioner, Instructions For Use.
Tighten:
-
both the mountings for the lateral link. Tighten to 80 Nm
-
the outer mounting for the tie rod. Tighten to 80 Nm
