S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
-
Install the hydraulic cylinder
-
Use tool 951 2923 Hydraulic hole cylinder See: Tools and Equipment/951 2923 Hydraulic Hole Cylinder with 999 7054 Adapter incl. 2x MC6C
M6X12 See: Tools and Equipment/999 7054 Adapter incl. 2x MC6C M6X12 , 999 7035 Sleeve See: Tools and Equipment/999 7035 Sleeve , 999
7036 Drift See: Tools and Equipment/999 7036 Drift and 999 7034 Connecting rod M12X400 See: Tools and Equipment/999 7034 Connecting
Rod M12X400
-
Pull the bushing until only approximately 2 mm of the bushing steel sleeve is visible
-
Remove the hydraulic cylinder.
Installing tie rod
Install:
-
the tie rod
-
the screw with the eccentric washer for the tie rod mounting (do not tighten).
Preparations for raising the suspension (AWD only)
-
Secure the control arms down. Use retaining straps
-
Remove the screw for the shock absorber mounting
-
Pull the shock absorber from its mounting
-
Release the retaining strap.
Warning! There is a risk of injury, do not place your hands in the surrounding area of the shock absorber when releasing the retaining strap.
Raising the suspension
Applies only to All-wheel drive (AWD):
-
Press the suspension up to its normal position, see Normal position See: Service and Repair/Procedures.
Does not apply to AWD:
-
Press the suspension up to its normal position, see Tensioner, instructions for use, AW55-50/51SN, 4T65EV-GT See: Service and
Repair/Removal and Replacement/Tensioner, Instructions For Use.
Applies to all models:
-
Tighten the outer mounting for the tie rod. Tighten to 80 Nm.
Note! Ensure that the eccentric washers are positioned in the previously marked position.