S80 T6 Executive L6-2.8L Turbo VIN 90 B6284T (2001)
Fluid Pressure Sensor/Switch: Service and Repair
Replacing pressure sensor
Removing the transmission side cover
See Removing gearbox side cover See: Service and Repair/Removal and Replacement/Automatic Transmission Components/Removing Gearbox Side
Cover.
Disconnecting the pressure sensor
Remove:
-
the clip for the cable harness from the pressure sensor
-
the connector
-
the screws.
Note! The upper screw is M10. The two shiny screws are self tapping.
Disconnect the pressure sensor.
Check that all (6 x) O-rings remain in the pressure sensor.
Installing the pressure sensor
