S90 L6-2.9L VIN 96 B6304S (1998)
Power Seat Motor: Service and Repair
Cable Replacement
Right Front Motor Cable Replacement
WARNING: Seats with SIPS bag must always have the transport safety device installed in order to avoid accidentally activating the system
when working on the seat.
Caution: While carrying out the following operations take care not to alter the position of the seat guide rails relative to one another. If the rails are
moved then it will not be possible to reinstall the seat in the vehicle.
Removing
Preparations
-
Make a note of radio code if anti-theft coded radio is installed.
-
Remove battery negative lead.
-
Cars with SIPS airbag: Install the transport safety device for the SIPS Airbag.
-
Remove seat from car.
-
Turn seat upside down and place on a clean surface.
Removal of brackets
-
Disconnect connector C on the control module.
-
Undo the four screws.
-
Remove brackets with the three motors.
Removal of right bracket
-
Remove right bracket which is secured by six screws.
Removal of drive cable to front motor
