S90 L6-2.9L VIN 96 B6304S (1998)
Move seat to rear most position.
Remove cover panel over the left seat adjustment rail.
Remove seat bolts at front edge.
Move seat to furthest adjustment point to the front.
Remove cover panels over the seat adjustment rails.
Remove bolts at rear edge.
Turn Ignition Off
Disconnect cable from negative battery terminal.
Disconnect the connector below the left seat adjustment rail.
Move seat to the rear until the guide lugs in the seat free off.
Lift seat straight up.
Remove seat from car.
Installing The Front Seat
First make sure that the SIPS bag safety on the new front seat has been applied by installing the transport safety device on the sensor module.
Install the seat in the reverse order of removal.
Tightening torques:
-
Seats/floor: 50 Nm (37 ft.lbs)
-
Belt: 30 Nm (22 ft.lb.)
