S90 L6-2.9L VIN 96 B6304S (1998)
7. Remove screw to track rod.
-
Pull off the rod from the wheel bearing housing.
-
Screws to support arm.
Tap the arm so it slides off the bushing.
-
Remove nut to the link screw.
Tap out the screw using a brass drift.
-
Remove the wheel bearing housing from the upper link.
Rest the housing on the lower link.
-
Remove the screws in the front and rear edge of the link.
-
Remove link from rear axle beam.
Replacing Link Bushings With The Link Removed.
8. Removing outer bushing as follows:
-
Put the link in a vice.
-
Pry up edges on two sides.
Use a chisel.