S90 L6-2.9L VIN 96 B6304S (1998)
13. Press in the bushing.
-
Line up the bushing in relation to the link.
-
Press in the new front bushing.
-
Use drift and counterhold.
Replacement Of Link Bushing In Rear Axle Beam
NOTE: This operation requires that both left and right links are removed.
14. Hang up the wheel bearing housing:
-
Use hook. Hang hook in the damper's upper hole in the body.
-
Remove the support arm:
The three screws and the nut.
Then the support arm from the car.
-
Lower the link with the compression tool.
-
Repeat operation on the other side of the car.
-
Remove compression tool.
15. Detach propeller shaft from gearbox.
-
Use sleeve tool, lower the propeller shaft front end carefully so the cable to the oxygen sensor (H02S) is not damaged.
-
Remove screws to the propeller shaft intermediate bearing bracket.
