S90 L6-2.9L VIN 96 B6304S (1998)
6. Remove:
-
Track rod screw and tap off rod from wheel bearing housing.
-
Nut to link screw in the wheel bearing housing.
Tap out the screw.
Use a brass drift.
7. Slacken the link inner nut.
-
The end of the screw should project 1-2 mm outside the nut.
8. Tap out the screw.
-
Use a brass drift.
-
Tap until the nut touches the link.
9. Lower tool and link completely.
-
Inspect and retain the spring mountings in the link.
10. Remove Compression Tool.
-
Repeat operations on the other side.
11. Loosen screws on lower rear axle beam.
-
Slacken all screws approx. one turn.
12. Remove:
-
The two front screws.
-
Spacers.
