S90 L6-2.9L VIN 96 B6304S (1998)
-
Coat rear sealing face of housing with liquid sealing compound (liquid gasket), P/N 1161409-6.
-
Apply bead approx. 2 mm thick. Also apply compound around bolt holes.
-
Reinstall housing (six bolts).
NOTE: Ensure that spacer is in position on output shaft.
-
Apply thread sealing compound to bolts. Tighten diagonally to 34 Nm (25 ft lb).
-
Attach torque strut to gear selector unit with washer and snap ring
-
Install drive flange Install washers (two).
-
Install new 0-ring in flange. Grease 0-ring lightly with Vaseline or ATF fluid.
-
Install new nut using locking fluid, P/N 1161053-2 or 1161054-0. Use counterhold 999 5149 and tighten nut to 123 Nm (91 ft lb).
-
Further secure nut by deforming (upsetting).
-
Reassemble propeller shaft with drive flange using new bolts and nuts. Tighten diagonally to 50 Nm (37 ft lb).
-
Ensure that propeller shaft and drive flange mating faces are clean and free of grease. Use special tool 999 5244.