S90 L6-2.9L VIN 96 B6304S (1998)
-
Mount connector on kickdown switch.
-
Install spring clip on cable adjuster. Hook cable onto TB pulley.
-
Install 3.5 mm shim between TB pulley CTP stop, ensuring that spring clip is seated against bracket, and adjust cable to light tension.
-
Remove shim.
-
Remove spring clip and install cable adjuster in bracket with clip.
-
Install TB cover.
-
Install TCM.
-
Mount TCM on bracket, ensuring that locking tabs engage with clearly audible snap.
-
Check that cable is not taut.
NOTE: Illustration shows location on earlier models. Following point applies only to cars with SRS.