V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Transfer the spring (1) to the new motor. Wrap the masking tape (2) around the spring to protect the motor.
Install edge trim (3), length 115 mm, if not already installed. See the illustration.
Slide the motor on the shaft as close to the end position as possible.
Route the wiring through the lower side of the frame. Press the connector in the frame. Connect the connector.
Install the wiring. Secure the wiring using a tie strap.
Secure the disconnected connector. Use a tie strap. Secure the cable harness in the frame.
