V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Check that the cable is still in the correct position in the cable terminal.
-
Apply pressure to the grip of the crimp tool
Do not release the pressure on the tool until it is at the final position. Only when the crimping operation is completed will the tool open.
Proceed
Inspect the crimped terminal
Always inspect the crimped cable terminal as described in Examples of correct terminal crimping See: Checking the Result Of the Crimping
Operation/Examples Of Correct Terminal Crimping Examples of incorrect crimping See: Checking the Result Of the Crimping Operation/Examples Of
Incorrect Crimping.
After checking the cable terminal
-
To insert the cable terminal in the housing, continue to When cable terminal is to be inserted in a housing See: Inserting a Cable Terminal In a
Housing/When Cable Terminal Is To Be Inserted In a Housing Closing the housing See: Inserting a Cable Terminal In a Housing/Closing the
Housing.
Operating Procedures For Repairs
Proceed as follows
The following chapter is arranged as follows
Using the information in this chapter most housings can be opened and the cable terminals replaced.
Note that the stages in the operations can be used with most housings/cable terminals and that the illustrations only show a few individual types as
examples. Other types can occur.
The basic instructions for the repair/replacement of cable terminals are only a summary of the contents of the manual, with references to respective
chapters/operations.
Caution! Note the contents of the section , these instructions must be followed before carrying out any repair work.
