V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
There are two sizes of the cavity opening.
See illustration.
Choose a terminal removal tool with ends which match the cavity opening extraction groove.
-
The narrow ends are 1.5 mm wide.
-
The wider ends are 2.7 mm wide.
Press the cable terminal in the cavity forwards as far as it will go to free the locking tab from the cavity catch.
Insert the terminal removal tool in the groove as illustrated.
Always follow the instructions in When secondary locking is of the lid type See: Open the Connector/When Secondary Locking Is of the Lid Type
which give the correct working procedure.
-
Proceed to chapter New cable terminal See: Replacing Cable Terminals/New Cable Terminal Seal SWS and plug See: Replacing Cable
Terminals/Seal SWS and Plug. Replacing a cable terminal in order to crimp a new cable terminal.
Housing With Half-Open Contact Side
Housing with half-open contact side
(When the cable terminals are partly exposed with the locking tabs visible in the cavities)
Housings of this type have partly exposed cable terminals on the contact side with the locking tabs visible in the cavities.
Usually this type only includes tab cable terminals with one locking tab.
Illustrated are:
