V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Ignition Coil: Procedures
Special Tools
999 5702
Removing ignition coil(s)
-
Remove both engine covers.
-
Disconnect the connectors.
-
Disconnect the HT lead.
-
Remove the mounting screws.
-
Pull off the ignition coils.
Installing ignition coil(s)
-
Check the rubber and the spring inside. Replace if necessary.
-
Position the ignition coils. Press the ignition coils into place.
-
Tighten the screw. Tightening torque 10 Nm.
-
Connect the high tension cables.
-
Reconnect the connector.
Note! The gray connector is for the left coil (cylinders 2 and 3), the blue connector is for the right coil (cylinders 1 and 4).
-
Check the function.
-
Reinstall both engine covers
