V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
If necessary, remove the rubber and the spring from the spark plug or from the spark plug hole.
Check and clean the spark plug if necessary.
Clean the ignition coil.
Fit the new spring (1) with the countersink outwards. Guide in the new spring (1) with a small screwdriver by pressing down the lower part of the spring
in the coil.
Note! Check that the spring (1) is raised out of the coil by approx. 5 mm.
Fit the new rubber in the groove on the ignition coil (2).
Installing the ignition coil(s)
-
Check the inside of the rubber and spring. Replace if necessary.
-
Fit the ignition coil and press in.
-
Fit the bolt. Tightening torque 10 Nm.
-
Connect the high voltage cables.
-
Connect the leads.
Note! The grey connector is for the left-hand coil (cylinder 2 and 3), the blue connector is for the right-hand coil (cylinder 1 and 4).
-
Carry out a function check.
-
Fit the engine's splash guard.
