V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Knock Sensor: Procedures
Preparations
Remove
-
The relay cover.
-
The trim cover.
-
The connector from the bracket. Open the two clamps. Pull out the cable from the protective tube.
-
The battery negative lead.
-
The front engine cover.
-
The starter motor, see Engine replacement, transfer of components.
Replacing the knock sensor (KS)
Remove
-
The screw.
-
The Knock Sensor (KS) from underneath. Remove the assembly with its wiring.
Install:
-
The Knock Sensor (KS) from underneath. Tighten the nut to 20 Nm.
Note! Install the Knock Sensor (KS) as illustrated.
Installing components
