V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Hazard Warning Switch: Procedures
Replacing warning lamp switch
-
Remove the knobs from the heater control; insert a small screwdriver at the rear edge under each knob.
-
Remove the heater control panel (insert two fingers into the opening and carefully pull out the control panel).
-
Remove the two upper mounting screws (torx) for the heater control panel.
Carefully pry out the ventilation vents with a small screwdriver.
-
Press the catches on the panel downwards from the inside using a screwdriver. Pull the panel forward slightly.
-
Press in the two retaining clips on the switch. Pull the switch out backwards.
-
Disconnect the connector.
Reinstall the components in reverse order.