V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
A seal must always be used for cable terminals with the designation SWS.
How to identify a cable terminal that requires a seal:
-
If there is a hole or slot (see arrow in illustration) in the insulation wings a seal must be used.
Seals are used where the cables are exposed to aggressive environmental factors and there is a risk of moisture penetration in the housing cavities.
The rubber-based seals prevent oxidization and retain moisture proof properties even when subjected to heavy vibration and extremes of temperature.
The seals are crimped round the cable at the insulation wings on the cable terminal.
The seals have different colors which are coded according to size as shown in the table below.
Plug
Plugs are used to close the unused cavities in a moisture proof housing.
A plug is in principle like a seal but without a hole in it for a cable.
Plugs are included in the repair kit p/n 981 4235 Replaced by 9512644 See: Tools and Equipment/981 4235 Replaced By 9512644 for housings with
cable terminals of the type 2.8 SWS.
New Cable Terminal
