V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Washer Fluid Level Switch: Procedures
Replacing/Removing The Washer Level Sensor
-
Ignition off
-
Remove the front splashguard on the right hand side to access the pump
-
Drain the reservoir
-
Separate the connector
-
Remove the sensor. Press it out carefully using a large screwdriver.
Install the windshield washer fluid sensor
Hint: Before installing the pump, immerse the housing in water or a soap solution to avoid compressing the rubber seal.
-
Install the sensor. Press it carefully into place.
NOTE: Correct sensor position (flat edge to the right)
-
Connect the connector to the sensor
-
Fill the reservoir. Check for leakage
-
Install the front splashguard.