V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
-
Install the central front-rear member and the two screws in the engine mountings.
-
Install the front-rear member with the long screws at the front and the short screws at the rear. Tighten to 69 Nm.
-
Tighten the two mounting screws for the engine at the front and rear.
-
Tighten the rear screw first. Tighten to 55 Nm.
Install:
-
the front engine splash guard
-
the wheel, remove the support.
Installing the steering gear housing on the steering column
-
Press the pinion shaft down as tar as It will go.
-
Tighten the screw. Tighten to 17 Nm.
-
Install a new tie strap on the intermediate plate.
-
If there is a gap, cut of the tie strap and degrease the area (use Loctite 7063).
-
Apply sealing compound (Loctite 3423) between the rubber hose and the steering column.
-
Install a new tie strap.
-
Install the rubber seal.
-
Tighten the tie strap carefully.
Note! The sealing agent must be left to dry for 3 hours before the car is driven.
The following tools are used when using Loctite 3423:
