V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Clean the tie rod mounting.
Position the new lock plate (or spacer) with the flange against the steering rack. Align the plate with the connection ring for the steering rack.
Turn the tie rod ± 7 mm up on the steering rack. Secure the flange in the snap ring for the steering rack. Finger tighten the tie rod.
Apply tape to the threads on the tie rod to prevent damage.
Secure the tie rod. Use special tool 999 7019 Lock key See: Tools and Equipment/999 7019 Lock Key. Tighten to 88 Nm.
Removing the counterhold
Remove the counterhold.
Secure the locking washer (at least 1) by tapping the lock plate (if lock plates are installed).
Clean the surfaces of the steering rack thoroughly after removing the tool.
Install the boot and the ball joint on the tie rod. See Installing the boot and Installing the ball joint on the tie rod.
Installing the boot
