V40 L4-1.9L Turbo VIN 25 B4204T2 (2000)
Torque: 25 Nm.
Ensure that the cable harness is correctly positioned.
Connect the cable harness connectors (gray).
Secure the cable harness with the tie straps.
Install the bracket for the connectors.
Torque: 10 Nm.
Installing the gear-shift position sensor
Ensure that the holder / spacer for the solenoid cable harness is in position.
Install:
-
The sensor. Finger tighten the mounting screws.
-
The rubber washer, the lock washer and the nut for the gear shift linkage rod. Torque: 25 Nm. Lock the nut with the washer.
Adjusting and checking
Adjust the gear-shift position sensor.
Installation
Install:
-
The bracket for the dip stick pipe. Ensure that the O-ring is in position. Tighten the nut.
Torque: 25 Nm
-
The lever on the gear shift linkage rod.
Torque: 16 Nm
-
The transmission cable on the lever with a washer and retaining clip. Apply a small amount of grease (P/N 1161241-3) to the lever shaft journal. If
the transmission cable bracket was removed: Install the bracket. Adjust the transmission cable.
